Jan Neukirchen

all works

Big Data (3D-Drucke)

A grey block of foamed polystyrene, a hollow milled into its top holding a branching white structure of thin rods
Paderborn, 27.2.–1.3.2015
A flatter grey block, an elongated white structure of a few parallel rods rising from the hollow
Osnabrück, 6.3.–8.3.2015
A grey block, a few short white rods lying in the hollow above a dark surface
Göttingen, 1.3.–2.3.2015
year
2015
form
Print
material
3D print in white ABS plastic on a polystyrene block with a milled negative form
dimensions
6.65 × 8.5 × 4.4 cm

This text is only available in German so far.

Algorithmus zur Herstellung der Plastiken

  1. Clusterbildung: Ein Datenblock beginnt, wenn eine Stadt betreten wird. Er endet, wenn die Stadt wieder verlassen wird.
  2. Abbildung: Die aufgezeichneten Daten werden auf Punkte im dreidimensionalen Raum abgebildet: Breitengrad auf x, Längengrad auf y, Zeit auf z.
  3. Interpolation: Die Daten zwischen den einzelnen Messpunkten werden interpoliert.
  4. Dimensionserhöhung: Aus den einzelnen Datenpunkten wird ein Volumenkörper erzeugt.
  5. Druck: Der Volumenkörper wird von einem 3D-Drucker materialisiert.

next

all works